Dynalink Wireless LAN Client USB WLL013 用户手册
4.
In SSID, enter the SSID. All wireless clients must use the same SSID in order
to communicate with each other.
to communicate with each other.
5.
Click Submit.
The wireless link quality indicators are not available for this mode.
3.2
WINDOWS XP ONLY
Pages 34-42 of the User’s Manual on CD describe every individual function of
the utility. Please refer to these pages for all the details as required.
the utility. Please refer to these pages for all the details as required.
Your wireless adaptor uses the Windows built in Wireless
Network Connection utility for configuration and monitoring.
Network Connection utility for configuration and monitoring.
The utility can be accessed via the Network Connection icon on the system tray.
Connecting to an existing access point or wireless station
1.
1.
Double click the Network Connection icon to open the Connect to Wireless
Network window. You will see all the access points or wireless stations that
are available.
are available.
2.
Select the access point or wireless station you intend to connect to.
3.
If the target network has been set with WEP, you must enter the same WEP
key in the Network key field. Otherwise leave blank. If WEP is not used, tick
the Allow me to connect… box
the Allow me to connect… box
4.
Click Connect to join the target network.
After successful connection to the target
network, double-click the icon on the
system tray again. The Wireless Network
Connection Status window displays the
link status.
that you wish to connect to. Open Wireless
Network Connection Status window, click
Properties. Select the Wireless Networks
tab. Under the Preferred networks section,
click Add. Enter necessary network settings
such as SSID and, if required, the network’s
WEP settings. You must enter the same
WEP key already in use by the network.
network, double-click the icon on the
system tray again. The Wireless Network
Connection Status window displays the
link status.
that you wish to connect to. Open Wireless
Network Connection Status window, click
Properties. Select the Wireless Networks
tab. Under the Preferred networks section,
click Add. Enter necessary network settings
such as SSID and, if required, the network’s
WEP settings. You must enter the same
WEP key already in use by the network.
Please make sure in the Authentication
tab Enable network access control using
IEEE802.1X is disabled.
tab Enable network access control using
IEEE802.1X is disabled.
WLAN PCMCIA Card/USB Adaptor Quick Set-up Guide