DSCover Satellite Products Home Security System SCW904x 用户手册
Self Contained Wireless Alarm System v1.0
58
4.
Initiating, Control and Termination of the Session: The Operator controls the session the using the following Audio Control Telephone
Key Functions.To select the following commands, Press [*][0] followed by the key number(s) indicated below
Key Functions.To select the following commands, Press [*][0] followed by the key number(s) indicated below
VOX Support
When in VOX mode the SCW9047 automatically switch between the phone line and internal mic/speakers being active depending on which
one is loudest. Push to Talk overrides VOX – this is performed by switching into a talk mode at the monitoring station .
When in VOX mode the SCW9047 automatically switch between the phone line and internal mic/speakers being active depending on which
one is loudest. Push to Talk overrides VOX – this is performed by switching into a talk mode at the monitoring station .
Hang-up Auto-detection
The SCW9047 automatically disconnects if the central station receiver disconnects before the operator picks up the line. The SCW9047 will
consider five seconds of continuous dial tone, or busy tone to be a disconnect condition.
The SCW9047 automatically disconnects if the central station receiver disconnects before the operator picks up the line. The SCW9047 will
consider five seconds of continuous dial tone, or busy tone to be a disconnect condition.
Bell/Buzzer Silent During 2-Way Audio
When the panel has an audible alarm, the bell can be programmed to remain active until the 2-Way Audio session starts and then the bell will
be silent (Section [600], option 7 off) to allow the user to hear the operator. All buzzer activity, except keypresses, will be silent when 2-way
audio is active. If the panel has not been disarmed at the termination of the 2-Way Audio session, the bell will restart for the timeout dura-
tion. Door chime is disabled during a 2-way Audio session. Any activity that normally sounds door chime will occur and the door chime
will not sound.
When the panel has an audible alarm, the bell can be programmed to remain active until the 2-Way Audio session starts and then the bell will
be silent (Section [600], option 7 off) to allow the user to hear the operator. All buzzer activity, except keypresses, will be silent when 2-way
audio is active. If the panel has not been disarmed at the termination of the 2-Way Audio session, the bell will restart for the timeout dura-
tion. Door chime is disabled during a 2-way Audio session. Any activity that normally sounds door chime will occur and the door chime
will not sound.
Key
Command
Description
0
Future Use
1/4
Talk to Speaker
Connects the monitoring station to the speaker .
2
VOX Mode
Connects the monitoring station to the system in VOX Mode (See VOX Sup-
port below)
port below)
3/6
Listen to Microphone
Connects the monitoring station to the microphone.
4
Lo-Gain Talk to Speaker
Connects the monitoring station to the speaker at the low volume output
level.
level.
5
Future Use
6
Lo-Gain Listen to Micro-
phone
phone
Connects the monitoring station to the microphone at the low gain input
level.
level.
7
Extend Time
Restarts the session timer (90 seconds) to prevent timeout.
To extend the
time and take no other action use this function. Pressing any key
automatically extends the time.
automatically extends the time.
88
Future Use
99
Disconnect
Disconnects the session. The second ‘9’ must be pressed within 1 second of
pressing the first ‘9’.
pressing the first ‘9’.
Use the “Disconnect” key sequence before hang-
ing up during a Talk / Listen-In session.
WWW.DIYALARMFORUM.COM