Delta Tau GEO BRICK LV 用户手册
Geo Brick LV User Manual
Motor Setup
156
MOTOR SETUP
This section discusses manual (step by step) motor setup guidelines for stepper or servo motors. This
motor setup segment should be the last of a few necessary steps to properly configure a motor with Geo
Brick LV.
motor setup segment should be the last of a few necessary steps to properly configure a motor with Geo
Brick LV.
Motor Setup Flow Chart
The following chart summarizes the steps to implement for setting up a motor properly with the Geo
Brick LV:
Brick LV:
Factory Default Reset $$$***, Save, $$$
(recommended)
Encoder Software Setup. Verify Feedback.
(Not applicable for steppers)
Dominant Clock Settings
Motor Software Setup
Motor Type And Protection
(Power-On PLC)
Encoder / Motor wiring
Note
The following (Motor Setup) section assumes that feedback devices (if
applicable) have been setup properly, and that moving the
motor/encoder shaft by hand shows correct data in the position
window.
applicable) have been setup properly, and that moving the
motor/encoder shaft by hand shows correct data in the position
window.