Datacom Systems VS-1200 用户手册

Initial Configuration

4.3

MANAGEMENT Port Configuration (RJ45)

Once VS-1200 series connection is made to the

MANAGEMENT RJ45 port, open the terminal

emulation application and create a connection with settings that fit your needs:

The factory configured VS-1200 series IP Address, Subnet Mask and Default Gateway are as
follows:

IP Address: 192.168.1.1; Subnet Mask: 255.255.255.0; Default Gateway: 0.0.0.0

4.3.1

HyperTerminal

The following example utilizes Microsoft HyperTerminal. Any freely available terminal emulator may
be utilized, but please take note of the specific HyperTerminal setup settings if an alternate terminal
emulator is used.

IMPORTANT: For Host Address, if initial IP Address

HAS NOT BEEN

configured, use

192.168.1.1

(default) or

if initial IP Address

HAS BEEN

configured, use the

Local Area Network address input

during initial IP Address configuration.

HyperTerminal (terminal emulator) enter:

TCP/IP (Winsock)
Host Address: nnn.nnn.nnn.nnn [i.e., 192.168.1.1 or Local Area Network]
Port Number: 23

Set HyperTerminal (terminal emulator) properties

Under File>Properties>Settings

Emulation:

VT100

Under File>Properties>Settings>ASCII Setup

Check box:

Send line ends with line feeds

Check box:

Echo typed characters locally

After completing review of the

Command Line Interface (CLI)

section and

Exercise - CLI setting

Ports

section, detailed IP Address configuration can be found in the

IP Address Configuration

section.