Garmin 4.4 用户手册
Registering and deleting projectors for monitoring
14
B
After entering the details, click "Register" to start the
registration. When the message is displayed, click "OK".
registration. When the message is displayed, click "OK".
To continue registering other projector(s), repeat Steps 1 and 2.
q
Projectors that have been registered using automatic search are searched
for again by projector name each time EasyMP Monitor is started.
for again by projector name each time EasyMP Monitor is started.
C
To end the registration operation, click
in the top-right
corner of the window or click "Cancel".
The icon(s) of the projector(s) you registered will be displayed in
Grouping view or Detail list view.
Grouping view or Detail list view.
Refer to s "Monitoring window layout"
for details on using
the Grouping view and Detail list view.
Setting the range of addresses to do an automatic
search and registration
search and registration
q
Projectors that are using a serial W TCP/IP conversion adapter cannot be
detected.
detected.
Procedures for automatic search
Procedure
A
Right-click in Grouping view and select "New" - "Projector
(automatic search)".
(automatic search)".
The Create new projector (automatic registration) window will be
displayed.
displayed.
If Detail list view is displayed, select New - Projector (automatic
search)
search)
from the Edit menu.
B
Select the "Specify an address range and search." check box
and then enter "Start address" and "End address" in the
range.
and then enter "Start address" and "End address" in the
range.