BMW 2011 328i Coupe 业主指南

Refere

nce

At a gl

anc

Controls

ing

tip

Mobi

Resetting the system

Each time a tire inflation pressure has been
corrected or a wheel or tire has been changed,
reset the system.
For operating principle refer to page

Start the engine, but do not start driving.

Lightly push button

1 in the turn indicator

lever up or down repeatedly until the corre-
sponding symbol appears in the display
accompanied by the word "RESET".

Press button

2 to confirm your choice of the

Tire Pressure Monitor. The following dis-
play appears:

Press button

2 for approx. 5 seconds, until

the reading shown below is displayed:

Start driving.

After several minutes of driving time, the
adjusted inflation pressures will be adopted as
nominal values. The resetting is completed
automatically as you drive. The indicator lamp
goes out after the system reset is completed.
You can stop driving at any time. The resetting
continues automatically when you resume driv-
ing.

Message for low tire inflation pressure

The warning lamps come on in yellow
and red. In addition, a signal sounds.

There is a flat tire or substantial loss

of tire pressure.

The system was not reset after a wheel
change and will thus issue warnings at the
last initialized inflation pressures.

Cautiously reduce speed to below 50 mph/
80 km/h. Avoid sudden braking and steering
maneuvers. Do not exceed a speed of 50 mph/
80 km/h.

Do not continue driving if the vehicle is
not equipped with run-flat tires, refer to

page

142

; continued driving could result in a

severe accident.

Continuing to drive with a flat tire

Possible travel distance with complete tire
pressure loss:

With a light load:
1 to 2 persons without luggage:
Approx. 155 miles/250 km

With a medium load:
2 persons, cargo area full, or 4 persons
without luggage:
Approx. 95 miles/150 km

With a full load:
4 persons, cargo area full:
Approx. 30 miles/50 km

Drive cautiously and do not exceed a
speed of 50 mph/80 km/h.

When there is a tire pressure loss, the handling
characteristics change, e.g. there will be
reduced directional stability during braking,
braking distances will be longer, and self-steer-
ing response will change.