Bushnell DEEP SPACE 78-9003 用户手册

•

  Reflector Telescope Assembly

•

  Altazimuth Yoke Mount

•

  Variable Height - Hardwood Tripod

•

  20mm and 4mm focal length - .965” diameter eyepieces.

•

  3X Barlow Lens

•

  5 x 24mm Finderscope w/ focus adjustment

•

  Vertical Stabilizer Bar

•

  Accessory Tray

•

  Hardware Pack

Tripod leg:  3-2.25” bolts, 6 -0.687“ washers and 3-wingnuts
Accessory tray: 3-0.5” bolts, 6 -0.687“ washers and 3-wingnuts
Tripod Leg Lock Screws: 3 pc.
Stabilizer Bar: 1 Mounting Screw

1.  Remove telescope from the carton and Identify all components. READ THROUGH ASSEMBLY

 
2.  Set-Up Tripod

•

  Select one tripod leg and extend the 

Tripod Leg Middle Section (7).

 Using the 

included in the hardware pack, insert a 

 into the lower brackets on the 

  Tighten the 

 so that the 

 is securely in place. Repeat for the

remaining two legs.

1.  Attach Telescope and Finderscope

•

  Locate the pre-assembled

 

 and 

 

Locate the long bolts

and washers from the hardware pack. Position the mount over the 

 as shown 

 and align the holes in the 

 with the

holes in the mount. Insert the bolts through the holes at the top of a 

A washer should be positioned on both outer sides of the 

Attach a wing nut to the bolt, but do not tighten it all the way. Repeat on
the remaining two 

. Once you have attached all 

 to

the mount, securely tighten all wing nuts. Remove the 

 from the hardware pack and insert it into the opening

at the base of the 

•

  Locate the 

 with pre-assembled mounting bracket. Remove the two nuts located near the

front of the telescope (closet to the eyepiece) and place the 

 and bracket assembly over the

exposed screws. The 

 should point towards the 

Replace the nuts, and securely tighten the 

 and bracket assembly in place.

2.  Attach Accessory Tray

•

  Locate the 

 Using the accessory tray bolts, wingnuts and washers (

3-0.5” bolts, 6 -0.687“ 3-

wingnuts)

 connect the 

Accessory Tray  

to the

 

. Start with one tripod leg and attach

wingnuts. Wingnuts should be positioned beneath the accessory tray. Do not tighten wingnuts until all

 are attached as some adjustments may be required.