Britax BOULEVARD CS 用户手册

26

27

a

b

c

WARNING!

 

Only use the tether connector strap for 

rear-facing tether installation when there is NOT a designated vehicle 

tether anchor.

d

Consult your vehicle owner’s manual for 

1 

designated tether anchorage locations.
Locate the tether on the rear of the child 

2 

seat and remove the tether from the pouch. 
Place the tether up and over the child seat 

3 

back. 
Install the child seat using the LATCH 

4 

system or the vehicle belts according to the 

instructions in this manual.
Tilt the tether release tab then pull to fully 

5 

extend the tether strap into a “V” shape.
Locate the hook on the tether strap and 

6 

attach the tether hook to the vehicle’s 

designated tether anchor.

IMPORTANT: The tether should be hooked over, 

not under, the vehicle tether anchor.

Pull the tether adjuster strap to remove all 

7 

slack. Roll up excess webbing and store in 

tether pouch. 
Verify there is tension in the tether strap and 

8 

that child seat is properly secured. 

Because every vehicle model is different, 

sometimes you cannot find a location to 

properly anchor the tether. Use the tether 

connector strap to assist in creating an 

anchor point (Fig. D). 

Find a fixed vehicle anchor point that is 

1 

bolted to the floor.
If you cannot find an acceptable 

2 

location to create an anchor point, 

contact the vehicle manufacturer to 

identify a suitable tether connection 

point.
Route the tether connector strap around 

3 

the fixed vehicle anchor point.
Take the metal D-ring and thread it 

4 

through the webbing loop on the other 

end of the tether connector strap.
Pull the metal D-ring all the way through 

5 

until the tether connector strap is tight 

around the metal anchor.
Use the D-ring as an attachment point 

6 

for hook on tether strap.