Brady PAM 3000 用户手册

Printer-Applicator-System PAM 3000

Fig. 13b Power supply

Switch on the Printer

NOTICE !

Check all external connections before starting to print.

Make sure that the media is loaded corresponding to the instructions.

Check that the transfer ribbon is loaded properly before starting to print.

CAUTION !

Make sure that the slide valve of the lift cylinder is closed during operation (see

chapter 5). Otherwise the lift cylinder can be moved without control. This fact can

cause damages.

NOTICE !

Make sure that the pad is not covered by a label when switching on the device.

Switch on the compressed air supply.

Switch on the power supply (2) of the Printer-Applicator-System.

The printer carries out a short system test and following the display shows the system mode

"ONLINE". If a hardware failure occurs during the system test the type of the failure will be

shown. In this case the printer should be switched off and on again. If the failure occurs

again call for service.
If the display is not showing anything after switching on the printer, please check the following:

- the connection of the power cord is correct

- the fuse (1) that protects the power connection, is not defective