Brady PAM 3000 用户手册

Printer-Applicator-System PAM 3000

50

Memory Cards

The printer provides an option for using memory cards to permanently save graphics, fonts,

complete label formats, or database information.  Data transfer may be performed via

interface.

It is recommended that you make backup copies in case of malfunction of the original cards.

The printer is able to read from PCMCIA version 2.1 compatible sRAM cards or Flash-

EPROM cards.  The maximum memory capacity is 4 MegaByte.

Preparing the Memory Card

1

2

3

Fig. 14b  Write protection / Inserting the battery

The write protection of the card may be activated or deactivated by shifting the switch (1)

located at the front side of the card.  The interpretation of the setting may be read from an

imprint (3) on the back of the card.

If you want to format the card or write on it, switch off the write protection.

For replacing or inserting the battery in sRAM cards refer to the instructions of the

manufacturer.  In case the battery has to be replaced, it is usually found in a slot (2) above the

switch (1).

Installation of the Memory Card

Fig. 14c  Installation of the memory card            Fig. 14d  Connecting side

1

2

3

4

The front side of the memory card (1) is usually marked by the inscription "MEMORY CARD",

and an arrow (2) representing the direction of inserting the card into the drive.  There is also

an arrow (4) impressed into the frame of the memory card slot of the printer.

Insert the card (1) into the slot (3) so that the front of the card faces the arrow (4).

At the connecting side of the card there are different guides on the top and the bottom which

make it impossible to insert the card incorrectly.