Brady BP-IP300 用户手册
Loading the Ribbon and Material
29
5. Feed the label backing (Figure 23, 4) out between the control panel and
the printer.
6. Make sure that there is enough slack in the label strip so the printer can
be closed without pulling the label strip backward.
7. Close the printer cover (Figure 1, 9).
Feeding the Label — Tear-Off Mode
.
Figure 24, Tear-Off Mode
1. Load the labels on the material supply holder. Refer to Loading the
Material on page 25.
2. Position the label strip between the label guides (Figure 24, 3) and turn
the adjustment wheel (Figure 24, 2) to snug the guides just up against
the label strip. Be careful not to tighten the guides against the label strip
enough to crimp the label strip.
the label strip. Be careful not to tighten the guides against the label strip
enough to crimp the label strip.
3. Close the printer cover (Figure 1, 9).
1. Deflector
2. Adjustment Wheel
2. Adjustment Wheel
3. Label Guides
4. Print Roller
4. Print Roller
4
1
2
3