Bradley Smoker MG-2/TT 用户手册
Express® Lavatory System - MG-Series with TouchTime® Control
MG-2/TT
MG-2/TT
Installation Instructions
2
2/8/07
Bradley Corporation • 215-1480 Rev. E; EN 06-915
Pre-Installation Information
Barrier-free and ADA compliant - standard height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 34" above finished
floor to be compliant with Americans with Disabilities Act (ADA). When mounted at 34" rim height,
the MG-2/TT Express® Lavatory System meets ADA, ANSI and UFAS requirements for barrier-free
clearances, reaches and controls. Always check local codes and ordinances for compliance.
floor to be compliant with Americans with Disabilities Act (ADA). When mounted at 34" rim height,
the MG-2/TT Express® Lavatory System meets ADA, ANSI and UFAS requirements for barrier-free
clearances, reaches and controls. Always check local codes and ordinances for compliance.
Barrier-free and ADA compliant - juvenile height mounting
The MG-2/TT Express® Lavatory System must have a rim height no higher than 30" above finished
floor to be compliant with Americans with Disabilities Act (ADA) Accessibility Guidelines for
Buildings and Facilities: Building Elements Designed for Children's Use; Final Rule.
floor to be compliant with Americans with Disabilities Act (ADA) Accessibility Guidelines for
Buildings and Facilities: Building Elements Designed for Children's Use; Final Rule.
Texas Accessibility Standards compliant:
The MG-2/TT Express® Lavatory System meets Texas Accessibility standards (TAS) for barrier-free
clearances, reaches and controls. Always check local codes and ordinances for compliance.
clearances, reaches and controls. Always check local codes and ordinances for compliance.
TouchTime® switch and solenoid
Each sprayhead is controlled by a TouchTime® switch, enabling each user to activate a single flow
of water. Each valve uses less than half the maximum of hot water allowed by the
ANSI/ASHRAE/IESNA 90.1-1989 Standard.
of water. Each valve uses less than half the maximum of hot water allowed by the
ANSI/ASHRAE/IESNA 90.1-1989 Standard.
Supplies required for installation:
• (8) 3/8" wall anchors, bolts and washers to mount frame and bowl
to wall (minimum pull-out rating of 1,000 lbs.)
• 1/2" NPT hot and cold supply piping and 1-1/2" NPT drain piping
• 1/2" NPT street elbow
• 110 volt electrical outlet for 110/24 VAC plug-in transformer (supplied)
• 240/208-volt or 277-volt electrical outlet for optional electric tankless water heater
• 1/2" NPT street elbow
• 110 volt electrical outlet for 110/24 VAC plug-in transformer (supplied)
• 240/208-volt or 277-volt electrical outlet for optional electric tankless water heater