Boss Audio Systems RC-2 用户手册

下载
页码 44
 
22
 
Creating Loop Phrases by Recording Audio from a CD/Digital Audio Player
 
8.
 
When you are finished with playback, press 
the pedal twice.
 
*
 
Be sure to press the pedal two times within an interval of one second.
 
 
Be sure to connect the CD or digital audio player to the 
AUX IN jack. If anything is connected to the INPUT 
jack, no signals from AUX IN will be recorded.
With the factory settings, the RC-2 applies compensa-
tion to the AUX IN signal so that it sounds appropriate 
when played through a typical guitar amp.
When sound that's been recorded from a CD, digital au-
dio player, or similar source is played through a guitar 
amp, the midrange and high-frequency range of the 
sound tend to be emphasized.
If you wish to record the AUX IN signal without the 
compensation applied, you can defeat it using the fol-
lowing procedure.
 
Defeating AUX IN Compensation
 
1.
 
Set the MODE knob to 
.
 
2.
 
Hold down the SELECT/ENTER button and 
turn on the power to the RC-2.
 
3.
 
Confirm that the LOOP/ONE SHOT indicator 
is lit (green), the CHECK indicator is lit (red), 
the REC/PLAY/DUB indicator is lit (green),  
then release the pedal.
 
After the pedal is released, only the CHECK indicator 
will remain lit (red).
 
* This status is cancelled when the power is turned off; the 
next time the power is switched on, AUX IN compensation 
is enabled.
 <CAUTION>
• Unauthorized recording, distribution, sale, lending, public performance, broadcasting, or the like, in whole or in 
part, of a work (musical composition, video, broadcast, public performance, or the like) whose copyright is held 
by a third party is prohibited by law.
• Do not use this unit for purposes that could infringe on a copyright held by a third party. We assume no responsibility 
whatsoever with regard to any infringements of third-party copyrights arising through your use of this unit.
RC-2_e.book 22 ページ 2006年10月27日 金曜日 午前10時31分