Bosch 2000 用户手册
2000 Series | Program Entry Guide | 9.0
Test Timer
EN | 31
Bosch Security Systems | 7/05 | 35114F
9.0 Test
Timer
The prompts in this group configure the system’s
automatic test report timer.
automatic test report timer.
1 Test Interval
Default:
No Report
Selection: No Report, 1 Day, 7 Days, 28 Days
0 No
Report
1 1
Day
2 7
Days
3 28
Days
Set
Test Interval
to
No Report to disable the Test
Report feature.
Set
Test Interval
to
1 Day to transmit Test Reports
every 24 hours.
Set
Test Interval
to
7 Days to transmit Test Reports
every 7 days.
Set
Test Interval
to
28 Days to transmit Test Reports
every 28 days.
2 Hours to Next
Default:
0
Selection: 0 to 23
Enter the number of hours until the next Test Report
at this prompt.
at this prompt.
The system adds the entries in the
Hours to Next
and
Minutes to Next
prompts and waits that period before
it sends the next Test Report to the receiver. From that
report on, the system sends reports at the interval set
by the
report on, the system sends reports at the interval set
by the
Test Intrvl
prompt.
If both the hours and minutes are 0 (zero), the system
sends the next report one interval from the end of
your programming session.
sends the next report one interval from the end of
your programming session.
0101
0101
0101
0101
0101
If you use a remote programmer, the waiting
period begins after you complete the
programming session. If you did not send
program changes to the control panel
during the remote programming session you
must end the programming session with a
Reset Bye.
period begins after you complete the
programming session. If you did not send
program changes to the control panel
during the remote programming session you
must end the programming session with a
Reset Bye.
For D5200 Programmer or Keypad
programming, the waiting period begins
after you return the standby pin to normal
operation.
programming, the waiting period begins
after you return the standby pin to normal
operation.
3 Minutes to Next
Default:
0
Selection: 0 to 59
Enter the number of minutes until the next Test
Report at this prompt.
Report at this prompt.
The system adds the entries in the
Hours to Next
and
Minutes to Next
prompts and waits that
period before it sends the next Test Report to the
receiver. From that report on, the system sends
reports at the interval set by the
receiver. From that report on, the system sends
reports at the interval set by the
Test Intrvl
prompt.
If both the hours and minutes are 0 (zero), the
system sends the next report at the end of your
programming session.
system sends the next report at the end of your
programming session.
0101
0101
0101
0101
0101
If you are using a remote programmer, the
waiting period begins after you complete
the programming session. You must end the
programming session with a Reset Bye.
waiting period begins after you complete
the programming session. You must end the
programming session with a Reset Bye.
For D5200 Programmer or Keypad
programming, the waiting period begins
after you return the standby pin to normal
operation.
programming, the waiting period begins
after you return the standby pin to normal
operation.
4 Defer Test Rpt
Default:
No
Selection: Yes, No
0
No
1 Yes
Set the
Defer Test Rpt
prompt to Yes to defer the
Test Report one interval if another report is
transmitting in the current interval.
transmitting in the current interval.