BMW K 1100 LT/RS 用户手册
32.7
Removing and installing right handle-
bar fitting
bar fitting
•
Remove fuel tank.
•
[LT] Cut through cable clip (1).
•
Disconnect plug connection (2) for brake light
switch.
switch.
•
Release brake line (3) and close off.
•
Release multifunction switch (4).
•
Loosen cover (5) for accelerator cable.
•
Detach accelerator cable (6).
•
Remove handlebar weight (7).
•
Loosen clamping screw (8) from fitting housing.
•
Remove fitting.
•
Cut through rubber grip and remove.
•
Install in the reverse order of removal.
e
Caution:
Top up brake fluid, vent system!
L
Note:
Turn connection piece (3) of the brake line such that
the brake line does not chafe at any point when the
handlebar is turned.
the brake line does not chafe at any point when the
handlebar is turned.
X
Tightening torques:
Brake line ........................................................7 Nm
Bleed screw.....................................................7 Nm
Clamping screw...............................................5 Nm
Bleed screw.....................................................7 Nm
Clamping screw...............................................5 Nm
Setting:
Accelerator cable play
............. 0.75 mm (0.0295 in)
LT320040
3
1
1
4
4
2
1
LT320050
8
7
6
5