Benq MP511 用户手册
Operation
24
Operation
Start up
1.
Plug the power cord into the projector and into
a wall socket. Turn on the wall socket switch
(where fitted). Check that the Power indicator
on the projector lights orange after power has
been applied.
a wall socket. Turn on the wall socket switch
(where fitted). Check that the Power indicator
on the projector lights orange after power has
been applied.
The power cable used in the illustration may look
different to the power cable type used in your region.
Use only the power cable as supplied with the
projector, and which is suitable for your region.
different to the power cable type used in your region.
Use only the power cable as supplied with the
projector, and which is suitable for your region.
2.
Remove the lens cover. If it is closed, it could become
deformed due to the heat produced by the projection
lamp.
deformed due to the heat produced by the projection
lamp.
3.
Press
Power on the projector or
remote control to start the projector.
The Power indicator light flashes green
and stays green when the projector is
on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to
adjust the picture clarity.
The Power indicator light flashes green
and stays green when the projector is
on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to
adjust the picture clarity.
If the projector is still hot from previous activity, it will run the cooling fan for approximately
120 seconds before energizing the lamp.
120 seconds before energizing the lamp.
4.
If you are prompted for a password, press the arrow buttons to enter a six digit
password. See
password. See
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input signals. The current input source being
scanned displays in the upper left corner of the screen. If the projector doesn't detect a
valid signal, the 'No Signal' message will continue displaying until an input source
signal is found.
You can also press SOURCE on the projector or remote control to select your desired
input signal. See
scanned displays in the upper left corner of the screen. If the projector doesn't detect a
valid signal, the 'No Signal' message will continue displaying until an input source
signal is found.
You can also press SOURCE on the projector or remote control to select your desired
input signal. See
for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range'
see the message 'Out of Range'
displayed on a blank screen. Please change to an input signal
for details.
PUSH