Benq MP511 用户手册
Operation
27
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
display one full screen at a time.
Please decide if you want to activate the quick auto search function by performing the
following steps.
following steps.
1.
Press MENU/Exit on the projector or remote control to turn on the OSD menu.
2.
Go to SOURCE > Quick Auto Search menu.
3.
Press
Left or
Right on the projector or remote control to select On or Off.
4.
Press MENU/Exit to exit and save the settings.
•
The brightness level of the projected image will change accordingly when you switch
between different input signals. Data (graphic) "PC" presentations using mostly static
images are generally brighter than "Video" using mostly moving images (movies).
between different input signals. Data (graphic) "PC" presentations using mostly static
images are generally brighter than "Video" using mostly moving images (movies).
The input signal type effects the options available for the Picture Mode. See
for details.
•
The native display resolution of this projector is SVGA 800x600 in a 4:3 aspect ratio. For
best display picture results, you should select and use an input source which outputs at
this resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity.
See
best display picture results, you should select and use an input source which outputs at
this resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity.
See
for details.
•
After activating Quick Auto Search, the
projector will perform automatic source
search once you press SOURCE on the
projector or remote control.
projector will perform automatic source
search once you press SOURCE on the
projector or remote control.
i. Press SOURCE on the projector or
remote control. A source selection
bar displays.
bar displays.
ii. Press
Up or
Down until your
desired signal is selected and press
MODE/Enter.
MODE/Enter.
iii. The projector will start automatic
source search by detecting your
selected signal first.
selected signal first.
iv. The information of the first
detected source will display at the
upper left corner of the screen for 2
seconds.
upper left corner of the screen for 2
seconds.
•
If you turn off Quick Auto Search, you can manually cycle through the available input
sources by performing the following steps.
sources by performing the following steps.
i. Press SOURCE on the projector or remote control. A source selection bar
displays.
ii. Press
Up or
Down until your desired signal is selected and press MODE/
Enter.
iii. Once detected, the selected source information will display at the upper left
corner of the screen for 2 seconds. If there is multiple equipment connected to
the projector, you can press the button again to search for another signal.
the projector, you can press the button again to search for another signal.
D-Sub / Comp.
Video
S-Video