Beko 15LB250MID 用户手册

6 

Always use the mains cable supplied. First of all insert the mains cable into the input panel of 

the CTV, and only there after into the mains supply socket.

For your own safety read the following instructions carefully before attempting to replace the 

moulded mains plug. Please check the type of mains lead supplied with your television and 

refer to the appropriate information below.

IMPORTANT

The wires in the mains lead are coloured

in accordance with the following code:

Blue - Neutral

Brown - Live

As the colours in the mains lead of this

appliance may not correspond with

the coloured markings identifying the

terminals in your plug, proceed

as follows:

The wire which is coloured blue or

black must be connected to the

terminal which is marked with the

letter N or coloured black.

The wire which is coloured brown or red must be

connected to the terminal which is marked with the letter

L or coloured Red.

No connection is to be made to the Earth terminal of the

plug.

If a 13 Amp (BS1363) Plug is used, fit an ASTA

apporoved 5 A fuse

If your product is fitted with a moulded plug which

requires replacement please cut off and dispose of it

safely, then rewire as shown in the diagram to the left.

IMPORTANT

The wires in the mains lead are coloured

in accordance with the following code:

Blue - Neutral

Brown - Live

Yellow/Green - Earth

As the colours in the mains lead of this

appliance may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows:

The wire which is coloured green and yellow must

be connected to the terminal which is marked with

the letter E, or by the earth symbol, or coloured

green or green and yellow.

The wire which is coloured blue or black must be

connected to the terminal which is marked with the

letter N or coloured Black.

The wire which is coloured brown or red must be

connected to the terminal which is marked with the

letter L or coloured Red.

If a 13 Amp (BS1363) Plug is used fit an ASTA

approved 5 Amp fuse.

If your product is fitted with a moulded plug which

requires replacement please cut off and dispose of it

safely, then rewire as shown in the diagram to the left.

• 

Cover a table with a soft towel (or other protection to prevent damage to the TV or table)

• 

Carefully lay the T.V. front down on the table

• 

position the T.V. table stand  so that it hangs over the edge of the table

• 

Remove the screws that hold the stand to the T.V.

• 

Remove the stand.

• 

Attach any new brackets before lifting T.V. back up.

Note: Keep removed stand and screws safely for future use.