Behringer DSP8024 用户手册

下载
页码 36
29
ULTRA-CURVE PRO DSP8024
6. INSTALLATION
6.1 Mains connection
Before you switch on the unit, check that it is configured to match your AC mains voltage requirements. If it
does not comply, then it is necessary to switch the operating voltage to the correct supply requirements before
turning on the unit, otherwise the unit could be severely damaged. You will find this combined fuse holder/
voltage selector at the back, adjacent to the IEC receptacle. IMPORTANT: This does not apply for general
export models which are built for one operating voltage only.
The AC voltage selection is defined by the position of the fuse holder. If you intend to change the operating
voltage, remove the fuse holder and twist it by 180 degrees before you reinsert it. Matching the two markers
monitors the selected voltage.
The mains connection of the ULTRA-CURVE PRO is made by using a mains cable and a standard IEC
receptacle. It meets all of the international safety certification requirements.
+
If the unit is switched to an other operating voltage, the ruse rating must be changed. See the
technical specifications in the appendix.
6.2 Audio connections
As standard, the BEHRINGER ULTRA-CURVE PRO is installed with electronically servo-balanced inputs and
outputs. The new circuit design features automatic hum and noise reduction for balanced signals and thus
allows for trouble-free operation, even at high operating levels. Externally induced mains hum etc. will be
effectively suppressed. The automatic servo-function recognizes the presence of unbalanced connectors and
adjusts the nominal level internally to avoid level differences between the input and output signals (correction
6 dB).
+
Please ensure that only qualified persons install and operate the ULTRA-CURVE PRO. During
installation and operation the user must have sufficient electrical contact to earth. Electrostatic
charges might affect the operation of the ULTRA-CURVE PRO!
6. INSTALLATION