Behringer Europower PMP1000 业主指南

下载
页码 24
14
EUROPOWER PMP6000/PMP4000/PMP1000 User Manual
4.3  Loudspeaker connections
Your power mixer is equipped with high-quality loudspeaker  connectors , 
which ensure safe and trouble-free operation. The connector was especially 
developed for high-power loudspeakers. Once it is plugged in, it safely locks into 
position and cannot be accidentally disengaged. It prevents the occurrence of 
electrical shock and ensures the correct polarity. Each of the loudspeaker jacks 
carries only the assigned single signal (see the information given on the rear 
panel of the power mixer).
1-
2-
2+
1+
1-
2-
2+
1+
front view
rear view
Professional speaker connector
(compatible with Neutrik Speakon connectors)
Fig. 4.6: Professional speaker connector with polarity allocation
Please be sure to only use commercial cables (type NL4FC) for connecting your 
loudspeakers to the power mixer. Please check the pin assignment of your 
loudspeakers and cables dependent on the PMP speaker output you choose.
EUROPOWER PMP6000/PMP4000/PMP1000
OUTPUT A
1+
1-
2+
2-
MAIN L
x
x
MONITOR
x
x
MONO
x
x
OUTPUT B
x
x
OUTPUT B
1+
1-
2+
2-
MAIN R
x
x
MONO
x
x
MONO
x
x
BRIDGE
x
x
Tab. 4.1: Polarity configuration of speaker connectors
OUTPUT B
BRIDGE
1+
1+
2+
1+
1-
1-
8 Ω
4 Ω
8 Ω
4 Ω
16 Ω
8 Ω
OUTPUT B
Fig. 4.7: Pin assignment
5.  Wiring Examples
Fig. 5.1: Stereo operation
Loudspeaker connection (monitor mix)
Loudspeaker connection (monitor mix)
PMP1000
PMP4000
PMP6000 
(part view)
2 x BEHRINGER EUROLIVE Stack 
(B1800X & B1220, both passive)
2 x BEHRINGER F1220D 
(active)
front panel (part view)
Footswitch
Link Output
For stereo operation the POWER AMP switch  
(27)
  must be set to its upper position 
(MAIN or MAIN L/MAIN R). Outputs A and B provide the stereo main signal for 
passive speakers. The preamp monitor output is connected to two parallel active 
speakers, which are used as on-stage monitors. Use the footswitch to enable/
disable the effects processor.