Bushnell ONIX 400 364000 业主指南

26

Specifications and designs are subject to change without 

any notice or obligation on the part of the manufacturer. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1)  This device may not cause harmful interference, and 

(2)  This  device  must  accept  any  interference  received,  including  interference  that  may  cause  undesired 

operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to  radio  communications.  However,  there  is  no  guarantee  that  interference  will  not  occur  in  a  particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can be 

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 

one or more of the following measures:

   

· Reorient or relocate the receiving antenna.

   

· Increase the separation between the equipment and receiver.

   

· Connect the equipment into an outlet on a circuit 

   

different from that to which the receiver is connected. 

   

· Consult the dealer or an experienced radio/TV  

   

technician for help.

The ONIX complies with Part 15 of the FCC interference limits for Class B digital devices 

FOR  HOME  OR  OFFICE  USE.  These  limits  are  designed  to  provide  reasonable  protection 

against harmful interference in a residential installation, and are more stringent than “outdoor” 

requirements. 

The ONIX does not contain any user-serviceable parts. Repairs should only be made by an Authorized Bushnell 

repair center. Unauthorized repairs or modifications could result in permanent damage to the equipment, and 

will void your warranty and your authority to operate this device under Part 15 regulations.

The shielded interface cable which is provided must be used with the equipment in order to comply with the 

limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

ONIX400 1LIM QS Guide-Feb08 Revi26   26

2/20/08   8:56:07 PM