Bunn bunn tcd-1/2 业主指南

INTRODUCTION

These dispensers are designed to mix liquid tea concentrate with water to produce iced tea by the glass or pitcher. The

concentrate can be stored either inside the dispenser, or outside with a hose connection to the dispenser. The dispenser

must be placed on a sturdy counter or shelf.

PLUMBING REQUIREMENTS

This dispenser must be connected to a cold water system with operating pressure between 30 and 90 psi

(138 and 620 kPa) from a 1⁄2" or larger supply line. A shut-off valve should be installed in the line before the

dispenser. The water inlet fitting is 1/4" flare.

NOTE - Bunn-O-Matic recommends 1/4" copper (or 3/8" braided flex) tubing for all installations from the 1⁄2"

water supply line. A tight coil of copper tubing in the water line will facilitate moving the dispenser to clean the

counter top. Bunn-O-Matic does not recommend the use of a saddle valve to install the dispenser. The size and

shape of the hole made in the supply line by this type of device may restrict water flow.

As directed in the International Plumbing Code of the

International Code Council and the Food Code

Manual of the Food and Drug Administration (FDA),

this equipment must be installed with adequate

backflow prevention to comply with federal, state

and local codes. For models installed outside the

U.S.A., you must comply with the applicable Plumb-

ing /Sanitation Code for your area.

Artwork for P/N: 00656.0001
Artwork Rev: A
Drawn: REF
Date: 04/22/10

FAUCET UNDER PRESSURE

Shut off water before cleaning. Use only BUNN approved

faucet part #03260.0004 (Plastic Body Faucet, Locking

Handle), #03260.0009 (Plastic Body Faucet, Non-Locking

Handle) or #03260.0005 (Chrome Body Faucet), specifically

designed for this equipment. Close the water valve at night

or when not in use.

WARNING

Artwork for P/N: 38130.0000
Artwork Rev: D
Drawn: REF
Date: 07/11/07
Colors:

PANTONE 1375 C

PANTONE 108 C

PANTONE Process Black C

USER NOTICES

Carefully read and follow all notices in this manual and on the equipment. All labels on the equipment should

be kept in good condition. Replace any unreadable or damaged labels.

00656.0001

38130.0000

PRESSURE REGULATOR ADJUSTMENT

1. Pull Knob out to unlock.
2. Adjust to 20 psi while faucet
is open, dispensing product.
3. Push knob in to lock.

38465.0000

OPEN

38466.0000

As directed in the International Plumbing Code of the International Code Council and the Food

Code Manual of the Food and Drug Administration (FDA), this equipment must be installed with

adequate backflow prevention to comply with federal, state and local codes. For models installed

outside the U.S.A., you must comply with the applicable Plumbing /Sanitation Code for your area.

47629 121012