BrickHouse Security Automobile Alarm FT 6200 用户手册
Installation Guide
GuardFT 6200
Copyright © 2006 Guardian Mobile Monitoring Systems, Inc. All rights reserved.
www.guardianmms.com
www.guardianmms.com
Commercial Vehicle Productivity and Security
The Guardian 6200 is a high-performance beacon designed for commercial vehicle applications that require location
based services including productivity and security. It is ideally suited to installations in delivery and service fleets as
well as public safety, mass transportation, utility, and off-road or construction vehicles.
based services including productivity and security. It is ideally suited to installations in delivery and service fleets as
well as public safety, mass transportation, utility, and off-road or construction vehicles.
Security features include vehicle theft detection and recovery as well as a means of connecting optional auxiliary
sensors and panic buttons anywhere within the vehicle.
sensors and panic buttons anywhere within the vehicle.
1 Install Antennas
Kit Contents
• GPS Beacon device
• Combined GPS/GPRS antenna
• Wiring harness
• Mounting bracket and hardware
• Combined GPS/GPRS antenna
• Wiring harness
• Mounting bracket and hardware
Tools/Supplies Required
• Wire cutters / wire strippers
• Voltmeter (multimeter)
• Soldering iron / solder
• Electrical tape
• Plastic cable ties
• Screw drivers
• Wrenches/sockets
• In-line fuse holder
• 2-Amp fuse
• Voltmeter (multimeter)
• Soldering iron / solder
• Electrical tape
• Plastic cable ties
• Screw drivers
• Wrenches/sockets
• In-line fuse holder
• 2-Amp fuse
The Guardian 6200 comes with a combined GPS/GPRS
antenna module. It is to be installed in a location where the
GPS performance will be optimum. The integrated adhesive
patch will allow easy attachment to a window or non-
metallic panel.
antenna module. It is to be installed in a location where the
GPS performance will be optimum. The integrated adhesive
patch will allow easy attachment to a window or non-
metallic panel.
Determine the best location for the GPS Antenna
• The antenna is to be installed inside the vehicle – it is not
waterproof or weatherproof.
• The top side of the antenna module (identified by the
peel-and-stick adhesive patch) must have a clear signal
path to as much of the sky as possible.
path to as much of the sky as possible.
• If the installation is not required to be covert, an ideal
location is on the front windshield glass.
• For covert installations, an ideal location is under the
dashboard, as high and close to the front windshield as
possible (see diagrams).
possible (see diagrams).
• If installing in a car, the antenna can usually be mounted
on the rear window or in the trunk, under the rear deck,
as close to the rear window as possible.
as close to the rear window as possible.
• If there is not a suitable flat mounting surface on which
to stick the integrated adhesive patch, affix the antenna
module in place with a caulking type adhesive or plastic
tie wraps.
module in place with a caulking type adhesive or plastic
tie wraps.
• Coil and secure any loose or extra lengths of antenna
cables - do not allow antenna cables to kink.
For additional installation information please refer to the Installation Best Practices document available through the Resource Center in
your Dealer Portal.
your Dealer Portal.