Barco Laser Pointer 26-0405000-00 用户手册
116
PresentationPRO-II • User’s Guide
6. Operations
Using Remote Control
rëáåÖ=oÉãçíÉ=`çåíêçä
When PresentationPRO-II is controlled from an external controller, the
Remote Control
Menu is used to set the unit ID and enable/disable remote control itself. Please note the
following prerequisites:
following prerequisites:
•
Ensure that you know the unit IDs currently in use by the external controller. The
external controller will not allow PresentationPRO-II to connect if a duplicate ID is
assigned.
external controller will not allow PresentationPRO-II to connect if a duplicate ID is
assigned.
•
If an external router is to be connected to PresentationPRO-II, ensure that the
proper physical connections have been made, and that the router is properly
configured from the external controller.
proper physical connections have been made, and that the router is properly
configured from the external controller.
Use the following steps to place PresentationPRO-II under remote control:
1. Press {HOME} > {REMOTE CONTROL} to access the Remote Control Menu.
2. Set the Unit ID to a value that is not used within the external controller’s system.
3. Scroll to the Remote Control line turn it ON.
4. In the “Status” section, verify the following:
~
Connection status with the external controller.
~
Ctrlr IP — the IP address of the external controller.
~
Destination — the destination assigned to PresentationPRO-II.
~
Router — the utilization of routers, either internal or external.
Use the following steps to reestablish local PresentationPRO-II control:
1. On the Remote Control Menu, scroll to the Remote Control line turn it OFF. The
{
HOME} buttons reappears, the PresentationPRO-II front panel is re-enabled, and
all control now originates locally.
Important
When remote control is on, the {
HOME} buttons disappears,
the PresentationPRO-II front panel is disabled, and all control
originates from the external controller.
originates from the external controller.