Weslo WLEL19021 业主指南

Assembly requires two people. Place all parts of the elliptical trainer in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.  

Assembly requires that you have a phillips screwdriver                      , two adjustable wrenches                     , a
rubber mallet                        , and a pair pliers                        . 

1. While another person holds the Console (6) near the

Upright (3), insert the Resistance Cable (26) down
through the Upright. 

2. While another person holds the Upright (3) near the

Frame (1) as shown, connect the Extension Wire
(61) to the Sensor Wire (25).

Next, connect the Resistance Cable (26) to the
Lower Cable (59) in the following way:

• Refer to drawing A. Pull up on the metal bracket,

and insert the tip of the Resistance Cable (26) into
the wire clip on the Lower Cable (59) as shown. 

• Refer to drawing B. Firmly pull the Resistance

Cable (26) and slide it into the metal bracket on the
Lower Cable (59) as shown. 

• Refer to drawing C. Using pliers, squeeze the

prongs on the upper end of the metal bracket
together.

Slide the Upright (3) onto the welded bolts on the
Frame (1). Make sure that the Lower Cable (59)
doesn’t become caught on the Upright or the
Frame. Be careful to avoid pinching the Lower
Cable, the Resistance Cable (26), the Sensor
Wire (25), or the Extension Wire (61) between the
Upright and the Frame. Tighten an M10 Nylon
Locknut (29) onto each welded bolt.

59

59

26

Metal

Bracket

26

B

A

C

59

26

3

2

1

29

26

Welded

Bolts

61

59

25

1

6

26

3