Weslo 21600.1 业主指南
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the includ-
ed tools and your own adjustable wrench , Phillips screwdriver , and
pliers .
materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the includ-
ed tools and your own adjustable wrench , Phillips screwdriver , and
pliers .
Use the drawings below to identify the small parts used for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in
the parts bag, check to see if it has been preassembled.
drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is
the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in
the parts bag, check to see if it has been preassembled.
4
M10 x 60mm Button
Screw (33)–2
M8 x 20mm
Button Screw (34)–3
M6 x 15mm Button
Screw (46)–4
M8 Split
Washer (42)–3
M8 Washer
(54)–4
M8 x 55mm Button
Screw (30)–4
M4 x 25mm
Self-tapping Screw (41)–3
M8 Nylon
Locknut (10)–4
1. Slide the Rear Stabilizer (6) into the Frame (1).
Attach the Rear Stabilizer with four M8 x 55mm
Button Screws (30).
Button Screws (30).
6
30
1
2. Orient the Front Stabilizer (2) with the large holes
facing the Frame (1). Attach the Front Stabilizer to
the Frame with two M10 x 60mm Button
Screws (33).
the Frame with two M10 x 60mm Button
Screws (33).
1
1
2
33
2
Large
Holes
Holes