Intel DP45SG DP45SG-10PAKBNDL 用户手册

17 

Intel Desktop Board DP45SG includes an I/O controller that provides the following 
legacy I/O features: 
•  One serial port via an onboard header 
•  Consumer Infrared (CIR) support 
•  Low pin count (LPC) interface 
•  Intelligent power management, including a programmable wake up event interface 
•  PCI power management support 

Intel Desktop Board DP45SG provides the following expansion capability:  
•  Two PCI Express 2.0 x16 connectors (compatible with PCI Express 1.1 add-in 

cards) 

•  Two PCI Express 1.1 x1 connectors  
•  Three PCI bus connectors 

The BIOS provides the Power-On Self-Test (POST), the BIOS Setup program, and the 
PCI/PCI Express auto-configuration utilities.  The BIOS is stored in the Serial 
Peripheral Interface (SPI) Flash device. 

The BIOS can be updated by following the instructions on page 61 in Chapter 3. 

If you install a Serial ATA device (such as a hard drive) in your computer, the auto-
configuration utility in the BIOS automatically detects and configures the device for 
your computer.  You do not need to run the BIOS Setup program after installing a 
Serial ATA device.  You can override the auto-configuration options by specifying 
manual configuration in the BIOS Setup program. 

PCI* and PCI Express* Auto Configuration 

If you install a PCI/PCI Express add-in card in your computer, the PCI/PCI Express 
auto-configuration utility in the BIOS automatically detects and configures the 
resources (IRQs, DMA channels, and I/O space) for that add-in card.  You do not need 
to run the BIOS Setup program after you install a PCI/PCI Express add-in card.