Wasp Bar Code WPS100 用户手册
4-2
Wasp WPS100 Product Reference Guide
If you are not using a USB cable, you must select a host type (see each host chapter for
specific host information). After you hear the power-up beeps, select a host type. This only
needs to be done once, upon the first power-up when connected to a new host.
specific host information). After you hear the power-up beeps, select a host type. This only
needs to be done once, upon the first power-up when connected to a new host.
To return all features to their default values, all you need to do is scan the
bar code on page 4-5. Throughout the programming bar code menus, default values are
indicated with asterisks (
indicated with asterisks (
*
).
Scanning Sequence Examples
In most cases you need only scan one bar code to set a specific parameter value. For
example, if you want to set the beeper tone to high, simply scan the High Frequency
(beeper tone) bar code listed under
example, if you want to set the beeper tone to high, simply scan the High Frequency
(beeper tone) bar code listed under
on page 4-6. The scanner issues a short
high beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as specifying Serial Response Time-Out or setting Data
Transmission Formats, require that you scan several bar codes. Refer to
Transmission Formats, require that you scan several bar codes. Refer to
on page 8-9 for descriptions of
this procedure.
Errors While Scanning
Unless otherwise specified, if you make an error during a scanning sequence, just re-scan
the correct parameter.
the correct parameter.
*
High Frequency
Feature/Option
*
Indicates Default