Winegard TV Antenna SS-1000 用户手册
4
Mounting Options
Before assembly, determine the best location for HDTV signal reception.
Point antenna toward station transmitter. To find exact location, go to
www.antennaweb.org. Mount options are:
Point antenna toward station transmitter. To find exact location, go to
www.antennaweb.org. Mount options are:
• Exterior wall mount
(for masonry walls, you must provide anchors)
• Roof mount
• Attic mount
• Rail/deck mount
SS-2000 includes: (Amplified)
Assembled Antenna
Assembled mount pipe and foot
4 #12 x 5/8” plastite screws
Assembled Antenna
Assembled mount pipe and foot
4 #12 x 5/8” plastite screws
(attach mt. bracket to antenna)
2 U-Bolts and hex nuts
4 lag bolts
Power Supply
4 lag bolts
Power Supply
Figure 1
Elevation
Bracket
Bracket
Swivel Clamp
Assembly
Assembly
Mount Pipe
Clamp
Clamp
Mount Bracket
Antenna
(Comes
assembled)
(Comes
assembled)
(4) #12 x 5/8” Screws
Another mount option is Winegard’s DS-1000 combina-
tion mount for satellite dish and Square Shooter antenna.
This configuration will meet wind specs.
tion mount for satellite dish and Square Shooter antenna.
This configuration will meet wind specs.
DS-1000
SS-1000 includes:
Assembled Antenna
Assembled mount pipe and foot
4 #12 x 5/8” plastite screws
Assembled Antenna
Assembled mount pipe and foot
4 #12 x 5/8” plastite screws
(attach mt. bracket to antenna)
2 U-Bolts and hex nuts
4 lag bolts
4 lag bolts
5
Assembly
STEP 1. Connect coax cable*
(not provided) to coax con-
nection on back of antenna.
*Use RG-6/U coax cable.
(not provided) to coax con-
nection on back of antenna.
*Use RG-6/U coax cable.
STEP 2. Attach pipe and foot
at the location selected for
the antenna.
at the location selected for
the antenna.
If you are mounting on a ma-
sonry surface, you must
provide your own masonry
anchors.
sonry surface, you must
provide your own masonry
anchors.
If you are mounting on a rail-
ing, for example, two U-bolts
are provided for rails, pipes,
etc. up to 2” in diameter.
ing, for example, two U-bolts
are provided for rails, pipes,
etc. up to 2” in diameter.
STEP 3. Attach swivel
bracket assembly to back of
antenna, using screws pro-
vided (4 #12 x 5/8). Do not
overtighten.
bracket assembly to back of
antenna, using screws pro-
vided (4 #12 x 5/8). Do not
overtighten.
STEP 4. Mount antenna on
pipe/foot assembly attached
to selected location surface.
pipe/foot assembly attached
to selected location surface.
STEP 5. Attach coax cable to
mount pipe with weatherproof
tape or cable ties.
mount pipe with weatherproof
tape or cable ties.
Coax Connection
Figure 2
Figure 3
NON-AMPLIFIED MODEL
SS-1000 ONLY
STEP 6. Connect coax cable from an-
tenna to your HDTV signal or analog
signal input. The connection depends
on your TV reception system setup;
check your component manuals.
SS-1000 ONLY
STEP 6. Connect coax cable from an-
tenna to your HDTV signal or analog
signal input. The connection depends
on your TV reception system setup;
check your component manuals.
Antenna and Mount
Assembled
Assembled