Winegard TV Antenna MODELS RS-3000 用户手册

下载
页码 7
RoadStar Antenna
RoadStar Antenna
Mounting Option 1
3
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Mounting Option 1, Cont.
4
12.
13.
14.
15.
16.
17.
18.
19.
20.
If installing the antenna so that the cable enters the vehicle directly 
beneath the antenna, follow the steps below for Mounting Option 1. 
Make sure the ceiling area is clear underneath 
the chosen location for the antenna.
Run coaxial cable from the chosen location for 
the power supply to the chosen location for 
the antenna.
Run the cable upward through the circular 
gasket and pedestal. 
Connect the coaxial cable running 
through the gasket and pedestal to 
the coaxial cable running from the 
antenna head.
Place the circular gasket in the 
chosen location for the antenna, 
and trace around the inner and 
outer edges of the gasket.
Check with the vehicle 
manufacturer for approved sealant 
for the vehicle. 
Then, apply a liberal amount of sealant between the inner and outer 
traced circles.
Replace the circular gasket where the sealant has been applied. 
Plug the slot in the pedestal with the 
provided rectangular gasket.
Before using the supplied screws, 
check with the vehicle manufacturer 
for any screw requirements. 
Then, align the holes in the circular 
gasket and pedestal. Mount the 
assembly to the roof with four 
screws, and tighten the four screws.
Run a solid bead of sealant where the edge of the pedestal and gasket 
assembly meets the roof and over the screw heads.
Gently push the cable slack downward through the pedestal. 
Twist the antenna head back and forth while pushing it onto the pedestal. 
The pedestal should engage with the snap ring inside the antenna head.
While applying pressure, rotate the 
head until feeling the grooves in 
the head line up with the grooves 
in the pedestal.
Push down again; you should hear 
the head click into place. 
Warning: Once the head and pedestal 
are connected, the head cannot be 
removed without incurring damage.
Check that the scribe line on the 
pedestal is no longer visible. 
If the 
scribe line is still visible, the head is 
not fully seated on the pedestal. 
Pull the antenna head upward. If 
the head is unable to slide upward 
on the pedestal, the head is fully 
seated on the pedestal. If the head 
slides upward, the head is not fully 
seated on the pedestal. 
If the antenna head is not fully 
seated on the pedestal, repeat the 
steps on this page to connect the 
antenna head to the pedestal.
Do not proceed until the head is fully seated on the pedestal.
Once the head is fully seated on the pedestal, continue with “Installing the 
Power Supply
” on page 7. If the power supply is already installed, make 
sure to run a channel scan after installing the antenna. See page 8 for 
more information.
Pedestal
Rectangular 
gasket
Slot
Coaxial cable 
running through 
gasket and pedestal
Coaxial cable 
running from 
antenna head
Groove
Vertical groove
Scribe line