Winegard Satellite TV System MV-3500 用户手册

2. Determine which programming you will be using. This will determine how you set your switches.

For DISH Network

, set switches to 119°.            For ExpressVu, set switches to 091°.

®

®

®

1. Remove screws holding dome to base and remove dome. Place dome in safe spot to avoid damage.
    Switches will be set at  101° for DIRECTV. You will be changing these switches.

DIRECTV receivers must be set to the two satellite, oval dish setting. Refer to your receiver manual.

DISH Network receivers must either have the check switch set for SW42 or unknown, no satellite found. See
page 4.

DISH NETWORK

  0     0      0       1       0       0      1      1

ExpressVu                0     1      0      1        1      0

1     1

1. Turn on receiver and television set. The MV-3500
must be connected to a receiver that is plugged
into 120 VAC.

2. Verify that you are getting the receiver’s menu
screens on the television. These screens are avail-
able with or without the dish finding the signal.

3. Turn the power switch on for the MV-3500.
The dish should start moving, making one or two
revolutions before it stops to acquire GPS. This can
take a few moments or up to 10 minutes. Normal
operation will be less than a minute.

4. Once the unit has acquired GPS, the dish will
begin its search.
a. The dish will pause on the signal long enough to
determine which satellite it has found.
b. If it moves off the signal , it is in an effort to verify
the signal and it should return to the signal shortly.

5. After the unit has verified that it has the correct
satellite, it will move to check the alternate satellite
before it  completes the search routine.

6.  If you do not have signal, see Troubleshooting,
p. 11.