White Outdoor 769-04211 用户手册

To remove and replace your snow thrower’s auger belt, 
proceed as follows:
1.  Remove the plastic belt cover on the front of the 

engine by removing the two self-tapping screws. See 
Figure 6-4.

2  Carefully pivot the snow thrower up and forward so 

that it rests on the auger housing. See Figure 6-5.

3.  Remove the frame cover from the underside of the 

snow thrower by removing four self-tapping screws 
which secure it.

4.  a. Roll the auger belt off the engine pulley.
  b. Use a wrench to pivot the idler pulley toward the 

right. See Figure 6-9.

  c.  Lift the drive belt off engine pulley.
5.  Back out the stop screw until the support bracket 

rests on the auger pulley. See Figure 6-10.

6.  Slip the drive belt off the pulley and between friction 

wheel and drive plate. See Figure 6-10.

7.  Remove and replace belt in the reverse order.

NOTE: Repeat the drive control adjustment on page 12 
before operating the snowthrower.

If the snow thrower fails to drive with the drive control 
engaged, and performing the drive control cable adjust-
ment fails to correct the problem, the friction wheel may 
need to be replaced. 

NOTE: Special tools are required and several com-
ponents must be removed and in order to replace the 
snow thrower’s friction wheel rubber. See an authorized 
Service Dealer to have the friction wheel rubber 
replaced or phone Customer Support as instructed on 
page 2 for information on ordering a Service Manual.

To inspect the friction wheel, proceed as follows:
1.  Carefully pivot the snow thrower up  and forward so 

that it rests on the auger housing. See Figure 6-5.

2.  Remove the frame cover from the underside of the 

snow thrower by removing four self-tapping screws 
which secure it. See Figure 6-5.

3.  Examine the friction wheel for signs of wear or 

cracking. See Figure 6-11.

If unit is to be stored over 30 days, prepare for storage 
as instructed in the separate engine manual packed with 
your snow thrower.

Clean snow thrower thoroughly.

•

Lubricate as instructed in the Maintenance section 

•

of this manual.

NEVER replace the 
auger shear pins with 
standard hex pins. 
Any damage to the 
auger gearbox or 
other components 
as a result of failing 
to do so will NOT be 
covered by your snow 
thrower’s warranty.

Refer to engine manual for correct engine storage 

•

instructions.
Store the snow thrower in a clean, dry area.

•

When storing any type of power equipment in a 

•

poorly ventilated or metal storage shed, care should 
be taken to rustproof the equipment, especially 
springs, cables and all moving parts.

c

a

b