Whirlpool UXT2030AYB 安装指导

NOTE: It is recommended that the vent system be installed 
before hood is installed.
Before making cutouts, make sure there is proper clearance 
within the ceiling or wall for exhaust vent.
1. Disconnect power.
2. Depending on your model, determine which venting method 

to use: roof or wall. 

3. Select a flat surface for assembling the range hood. Place 

covering over that surface.

4. Lift the range hood and set it upside down onto covered 

surface.

5. If cabinet has recessed bottom, add wood filler strips on each 

side. Install screws to attach filler strips in locations shown.

Cut only one 1

¹⁄₄" (3.2 cm) diameter wiring access hole.

1. Determine and clearly mark a vertical centerline on the wall 

and cabinet in the area the vent opening will be made.

1. Mark a line distance “A” from the right of the centerline on the 

underside of the cabinet. Mark the point on this line that is 

2" (5.1 cm) from back wall. Drill a 1¼" (3.2 cm) diameter hole 

through the cabinet at this point.

1. Mark a line distance “A” from the right of the centerline on the 

underside of the wall. Mark the point on this line that is 

⁷⁄₈" 

(2.2 cm) from the underside of the cabinet. Drill a 1

¹⁄₄" (3.2 

cm) diameter hole through the rear wall at this point. 

1. Mark a centerline on the underside of the top of cabinet.

2. Mark a line 

5" (12.7 cm) from the back wall on the underside 

of the top and bottom of cabinet.

3. Use a compass or a circle template to draw a circle with a 

diameter that is ¼" (0.64 cm) larger than the vent.

4. Use saber or keyhole saw to cut the circular vent opening.

1. Install vent through the vent opening in upper cabinet or wall. 

Complete venting system according to the selected venting 
method. See “Venting Requirements” section. 

2. Use caulking to seal exterior wall or roof opening around the 

cap.

³⁄₈" (21.3 cm) 

A

A

³⁄₈" (21.3 cm) 

A