Whirlpool MGDX500BW 尺寸示意图

A 120-volt, 60 Hz, AC-only, 15 or 20 amp fused electrical supply is required. A time-delay fuse or circuit breaker and a separate circuit  

are recommended. 

 

   

 

Gas supply

: 

This dryer is equipped for use with Natural gas. Dryer can be converted to L.P. gas. When rigid pipe is used it should be 1/2" IPS. When 

acceptable to the gas supplier and local codes, 3/8" approved tubing may be used for lengths under 20 ft (6.1 m). For lengths over 20 ft (6.1 m), larger 

tubing should be used. Pipe-joint compounds resistant to the action of L.P. gas must be used. An individual manual shutoff valve must be installed 

within 6 ft (1.8 m) of the dryer in accordance with the National Fuel Gas Code ANSI Z223.1. 

 

The location must be large enough to allow the dryer door to 

open fully.

Most installations require a minimum 5½" (140 mm) clearance 

behind the dryer for the exhaust vent with elbow. See “Venting 

Requirements.”

The dimensions shown are for the minimum spacing allowed.

 

■

Additional spacing should be considered for ease of installation 

and servicing.

 

■

Additional clearances might be required for wall, door, and floor 

moldings.

 

■

Additional spacing of 1" (25 mm) on all sides of the dryer is 

recommended to reduce noise transfer.

 

■

For closet installation, with a door, minimum ventilation 

openings in the top and bottom of the door are required. 

Louvered doors with equivalent ventilation openings are 

acceptable.

 

■

Companion appliance spacing should also be considered.