Whirlpool Dishwasher W10300929B 用户手册

NOTE: Fill amounts shown 
are for standard powdered 
detergent. Follow 
instructions on the package 
when using other dishwasher 
detergent types. 
Premeasured forms are suitable for all hardness and soil levels. 
Always place premeasured detergents in the main compartment 
and close the lid. 

■

Your dishwasher is designed to use rinse aid for good drying 
performance. Without rinse aid your dishes and dishwasher 
interior will have excessive moisture. The heat dry option will 
not perform as well without rinse aid.

■

Rinse aid keeps water from forming droplets that can 
dry as spots or streaks. They also improve drying by 
allowing water to drain off of the dishes after the final 
rinse.

■

Rinse aid helps to reduce excess moisture on the dish 
racks and interior of your dishwasher.

■

Check the rinse aid indicator. Add rinse aid when indicator 
drops to “Add” level.

■

To add rinse aid, turn the dispenser cap 
to “Refill” and lift off. Pour rinse aid into 
the opening until the indicator level is at 
“Full.” Replace the dispenser cap and 
turn to “Lock.” Make sure cap is fully 
locked. 

NOTE: For most water conditions, the 
factory setting of 2 will give good 
results. If you have hard water or notice 
rings or spots, try a higher setting. Turn 
the arrow adjuster inside the dispenser 
by either using your fingers or inserting 
a flat-blade screwdriver into the center 
of the arrow and turning. 

See “Cycle and Option Descriptions” charts in the following 
section.

Efficient dishwashers run longer to save water and energy, just as 
driving a car slower saves on gas. Typical cycle time is 
approximately 2

¹⁄₂ hours, but can take less or more time to 

complete depending on selections.

See “Cycle and Option Descriptions” charts in the following 
section.

You can customize your cycles by pressing the options desired. If 
you change your mind, press the option again to turn off the option. 
Not all options are available for every cycle. If an invalid option is 
selected for a given cycle, the lights will flash.

■

Run hot water at the sink nearest your dishwasher until the 
water is hot. Turn off water.

■

Press START/RESUME once to show which 
selections you used. Select the wash cycle and 
options desired OR press START/RESUME to repeat 
the same cycle and options as in the previous wash 
cycle.

IMPORTANT: If anyone opens the door (such as, for adding a dish, 
even during the Delay Hours option), the Start/Resume button 
must be pressed each time. 

■

If the Start/Resume button is located on top of door, push door 
firmly closed within 3 seconds of pressing START/RESUME. If 
the door is not closed within 3 seconds, the Start/Resume 
button LED will flash, an audible tone will be heard, and the 
cycle will not start.

Soft Water

Hard Water

Soft Water

Hard Water

Full

Add

¹⁄₄

Lock

Refill

6 5

4

3

2

max

fill

1

- -

-

-

- - -

-

-

-

-

6 5

4

3

2

max

fill

1

- -

-

-

- - - -

-

-

-

-