Whirlpool Dishwasher ADG 7445 用户手册

下载
页码 8
GB -5-
Switch off the appliance Everything o.k. ...
Wash cycle
Select programme
Quick, permanent or alternating
6
7
8
Exercise caution when opening the door: beware of hot steam.
Only press the OFF button once the START indicator lamp has switched off.
All the indicator lamps switch off. Unload the appliance, starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
Maintenance and care
Maintenance and care
Change the programme in progress:
• Press the START button (for 2 seconds) until the START indicator lamp 
switches off. 
• Close the door.
• (Water drains for up to 60 seconds).
• Open the door.
• Select a new programme.
• Press the START button.
Overview of programmes
The max. possible number of programmes is illustrated in the chapter “Chart”. The corresponding programmes for your appliance can be found on the panel (page 1).
Choose programme according to the attached table of programmes (page 1).
Duration of the programme depends on the external conditions in the apartment, temperature and pressure etc.
The dishwasher door must be closed and the water tap open.
To load crockery, open the door with caution:
Close the door again.
The programme resumes the cycle from where it was interrupted.
Beware of hot steam!
The wash cycle can be interrupted at any time by pressing START (see chapter “What to do if...”).
Rectifying minor faults yourself ...
10
9
Filters
Check and 
clean if 
necessary
Unscrew filter 
cylinder, remove it 
and fine sieve...
Rinse under running 
water ...
Screw on filter cylinder NOTE MARK!
Unscrew 
and remove 
upper arm ...
Spray arms 
Remove
blockages/
deposits.
Insert
Clean spray 
nozzles under 
running water
(use toothpicks if 
necessary) ...
Insert and screw on lower and upper arms tightly.
Unscrew 
and remove 
lower arm ...