Whirlpool Dishwasher ADG 175 用户手册
22
for personal safety:
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
FROM THE POWER CORD.
EARTHING
CONNECTION
Connect the cold water supply hose to a threaded 3/4 (inch) connector and make sure
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time , let the
water run to make sure that the water is clear. This precaution is needed to avoid the
risk of the water in let to be blocked and damage the a ppliance.
Th e water supply to the applianc e ca n also be connected to the house hold hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case , the wash cycle time will be shortene d by about 15
minute s and the wash efficiency slightly reduced .
Th e co nnection must be made to the hot water lin e followi ng the same procedures as
described in the sec tion for the c onnection to the cold water line.
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case , the wash cycle time will be shortene d by about 15
minute s and the wash efficiency slightly reduced .
Th e co nnection must be made to the hot water lin e followi ng the same procedures as
described in the sec tion for the c onnection to the cold water line.
WARNING!
Improper connection of the equipment earthing conductor can result in the risk of an electric shock.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
please have a qualified electrician to install a proper outlet.
Check with a qualified electrician or service representative if you are in doubt whether the
appliance is properly earthed.
Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet,
please have a qualified electrician to install a proper outlet.
In or der to avoid that there is more water staying in the inlet hose, please close
the hydrant after using.(Not applicable to appliances without aqua-stop.)
the hydrant after using.(Not applicable to appliances without aqua-stop.)
WARNING!
Water Connection
The following things should be checked before starting the dishwasher.
Syphon Connection
The waste conne ction must be at a he ight of be tween 50 cm (minimum) and 100 cm (maximum)
from the bottom of the dish. T he water drain ho se should b e fixed by a hose clip.
Start of Dishwasher
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher