Whirlpool GU2275XTV 用户手册

下载
页码 24
4
Depending on your water hardness, fill the Main Wash section 
of the dispenser as shown. Fill the Pre-Wash section to the 
level shown, if needed. 
NOTE: Fill amounts shown 
are for standard powdered 
detergent. Follow instructions 
on the package when using 
other dishwasher detergent. 
Add Rinse Aid
Your dishwasher is designed to use rinse aid for good drying 
performance. Without rinse aid your dishes and dishwasher 
interior will have excessive moisture. The heat dry option will 
not perform as well without rinse aid.
Rinse aid keeps water from forming droplets that can 
dry as spots or streaks. They also improve drying by 
allowing water to drain off of the dishes after the final 
rinse.
Rinse aid helps to reduce excess moisture on the dish 
racks and interior of your dishwasher.
Check the rinse aid indicator. Add rinse aid when indicator 
drops to “Add” level.
To add rinse aid, turn the dispenser cap 
to “Refill” and lift off. Pour rinse aid into 
the opening until the indicator level is at 
“Full.” Replace the dispenser cap and 
turn to “Lock.” Make sure cap is fully 
locked. 
NOTE: For most water conditions, the 
factory setting of 2 will give good 
results. If you have hard water or notice 
rings or spots, try a higher setting. Turn 
the arrow adjuster inside the dispenser 
by either using your fingers or inserting 
a flat-blade screwdriver into the center 
of the arrow and turning. 
Select a Cycle (cycles vary by model) 
See “Cycle and Option Descriptions” charts in the following 
section.
Heavier cycles and options affect cycle length. Some cycles and 
options will take up to 3
¹⁄₂ hours to complete.
Select Options (options vary by model) 
See “Cycle and Option Descriptions” charts in the following 
section.
You can customize your cycles by pressing the options desired.
Start or Resume a Cycle
Run hot water at the sink nearest your dishwasher until the 
water is hot. Turn off water. For best dishwashing results, water 
should be 120ºF (49ºC) as it enters the dishwasher.
Push door firmly closed. The door latches 
automatically. Select the wash cycle and options 
desired OR press START/RESUME to repeat the same 
cycle and options as in the previous wash cycle.
You can add an item anytime before the main wash 
starts. Open the door slowly and add the item. Close 
the door firmly within 3 seconds. Press START/RESUME.
Cycle and Option Descriptions
This information covers several different models. Your dishwasher may not have all the cycles and options described.
You can customize your cycle by selecting an option. 
See option selections. If you change your mind, press the option again to turn off the option, or select a different option. You can change 
an option anytime before the selected option begins.
*Maximum wash times depend on water temperature, heavy soil condition, dish load size and options selected. 
Soft Water
Hard Water
Soft Water
Hard Water
Main Wash
Pre-Wash
Full
Add
¹⁄₄
 turn to lock
Lock
Refill
6 5
4
3
2
- -
-
max
fill
1
- -
-
-
- - -
-
-
-
-
6 5
4
3
2
- -
-
max
fill
1
- -
-
-
- - - -
-
-
-
-
STEP 3
STEP 4
CYCLE SELECTIONS
CYCLES
DISH LOAD TYPES
DESCRIPTIONS
 WASH TIME (HH:MM)
Cycle 
Minimum
Cycle + Options 
Minimum
*Maximum
Use for all day-to-day soil 
types when washing full to 
partial dish loads. 
This cycle compensates for the size of 
the dish load by adding time and heat.
During the wash, the wash action will 
repeatedly pause for several seconds.
1:19
1:27
3:30