Siemens SC9000 用户手册

DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp.  Page 3 of 4 

INSTRUCTIONS FOR USE – M Series Pivot Arm 
 
Pivot 

 

1.  To pivot the Arm (near the wall), simply push on the side of the Arm or mounted device. 
2.  To adjust the pivot tension at the Slide, use a ½” (or 13mm) socket driver to tighten or loosen the Pivot  
 

Tension Bolt to obtain the desired tension. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Swivel 

 

1)  To rotate the device simply push or pull the corners of the device. 
2)  To adjust the swivel tension, use a ½” (or 13mm) socket driver to tighten or loosen the Swivel Tension Adjustment Bolt  
 

located under the front end of the Arm. 

1.  Grasp the top and bottom of the device and tilt it to the desired angle. 
2.  To adjust the overall tilt tension, evenly tighten or loosen the (2) #10-32 x 5/8” SHCS Tilt Tension Adjustment Screws  
 

using the supplied 5/32 (4 mm) hex key. 

 
 
 
 
 
 
 
 
 
 
 
 
Cable Management 

1.  An open cavity beneath the arm with flexible cable covers manage cables going to and from the front and rear of the  
 arm. 
 
 
 
 
 
 
 
 
 

Flexible Cable Covers

Pivot Tension Bolt

Swivel Tension Bolt