Ringdale Fax Receiver MFR-200 用户手册

PROBLEM: I am getting poor quality images in the Fax TIFFs.

CAUSE: Your image viewer does not properly support

tagged image file (TIF) format

. The

default Windows viewer should work fine.

SOLUTION: Try using Imaging or Imaging Preview that comes with Windows.

Right-click on the TIFF file and select Open With.

It will bring up the Open With window, where you can select Imaging or Imaging Preview.

You can also put a check in the "Always use this program to open these files" if you
wish.  Click OK.

PROBLEM: The sending fax reported "POOR LINE CONDITION".

SOLUTION: This could mean any of the following:

a)

The email parameters are not entered correctly.

The email is being rejected. (email box too full, spam filter parameters)

Ethernet cable is disconnected.

There is a poor line condition.

QUESTION:

How do I reset to the factory default settings

ANSWER: Unplug the power, press the reset button, plugging the power back in while
holding reset for 10 seconds

PROBLEM:

I enabled the DHCP setting, but do not know what address was used.

SOLUTION: After the IP address is assigned, ping the address or range of
addresses that it could have. Then within 5 minutes, use the ARP -A command to
see the IP Addresses assigned in that range. Look for IP Address assigned to the
Physical Address that has the last six digits matching the Fax Receiver’s serial
number.

Example:

C:\WINNT\system32>arp -a

Interface: 11.22.33.99 on Interface 0x1000003
  Internet Address      Physical Address      Type
  192.168.10.1         00-A0-92-bb-23-20     dynamic
  192.168.10.23        00-A0-92-65-ec-c4     dynamic
  192.168.10.36        00-A0-92-6d-7d-53     dynamic
  192.168.10.165       00-A0-92-83-8b-0c     dynamic

If the Fax Receiver's serial number is 838B0C then the IP Address is
192.168.10.165.