ResMed Flow Generator VPAP Adapt SV 用户手册
7
VPAP Adapt SV System
English
Figure 2: Rear of VPAP Adapt SV
See page 14 to connect a ResLink™. See page 30 to replace the air filter.
Figure 3: Air tubing fully assembled
All necessary air tubing components are packed with the VPAP Adapt SV:
•
a 6’6" (2 m) length of air tubing
•
a pressure sensor tube (to measure pressure at the mask) with Luer
connectors
connectors
•
tube clips (to hold the pressure sensor tube onto the air tubing)
•
a proximal cuff (a special connector that attaches the pressure sensor tube
into the main air tubing so you only need to make one attachment to the
mask).
into the main air tubing so you only need to make one attachment to the
mask).
The air tubing is supplied with the proximal cuff connected. Attach the tube clips
evenly along the air tubing. Press the pressure sensor tube into the tube clips,
and screw the Luer connectors together at the proximal cuff. Make sure the
pressure sensor tube is not kinked, obstructed or twisted.
evenly along the air tubing. Press the pressure sensor tube into the tube clips,
and screw the Luer connectors together at the proximal cuff. Make sure the
pressure sensor tube is not kinked, obstructed or twisted.
Note: ResMed recommends the following tubing products for use with the
VPAP Adapt SV: replacement air hose (only) PN14986; replacement air delivery
system (hose, sensor line, clips, proximal cuff) PN26923.
VPAP Adapt SV: replacement air hose (only) PN14986; replacement air delivery
system (hose, sensor line, clips, proximal cuff) PN26923.
Masks
You will also need a ResMed mask system (supplied separately). For the latest
available masks, see www.resmed.com. Please refer to the table on page 21 to
set up your mask correctly for use with the VPAP Adapt SV. Your clinician can
explain the features of the masks available and will discuss the mask that best
suits your needs.
available masks, see www.resmed.com. Please refer to the table on page 21 to
set up your mask correctly for use with the VPAP Adapt SV. Your clinician can
explain the features of the masks available and will discuss the mask that best
suits your needs.
Air filter
Power cord
ResLink attachment point
Proximal cuff
Pressure sensor tube
Tube clip
Connect this end
to the mask
to the mask
Connect this end to
the flow generator
the flow generator
Luer connector
Air tubing
228234 VPAP Adapt SV User Guide USA Eng.book Page 7 Monday, October 13, 2008 2:15 PM