Tow Ready Cequent Performance Products - Bike Rack 63130 用户手册
63130N 5-2-07 Rev A
63130
ONE PLACE ROOF TOP BIKE CARRIER
Figure 1
ITEM:
Cequent Towing Products - Plymouth, MI
Technical Service: (888) 521-0510
www.towready.com
Hex Nut
Plastic Knob
Page 1 of 9
DESCRIPTION:
Hex Bolt
Flat Washer
Figure 3
Figure 4
ASSEMBLY INSTRUCTIONS:
1.
1.
Assemble the Wheel Trays together using two hex
bolts, flat washers, and hex nuts. (Figure 1)
Do NOT cover load rating label.
bolts, flat washers, and hex nuts. (Figure 1)
Do NOT cover load rating label.
2.
Install the plastic End Caps to wheel trays.
3.
Attach the bike Support Arm Bracket to the wheel
trays using two hex bolts, flat washers, and hex
nuts. (Figure 3)
NOTE: The attachment location “A” varies by bike.
Use your bike as a guide to locate the Support Arm
bracket so that the angle between the Support Arm
and bike tube is approximately 90 degrees and that
the front wheel of your bike is locate as shown - see
figure 2.
trays using two hex bolts, flat washers, and hex
nuts. (Figure 3)
NOTE: The attachment location “A” varies by bike.
Use your bike as a guide to locate the Support Arm
bracket so that the angle between the Support Arm
and bike tube is approximately 90 degrees and that
the front wheel of your bike is locate as shown - see
figure 2.
4.
Attach the bike rack assembly to vehicle roof rack
FRONT cross-bar using the U-bolts and plastic
knobs. (Figure 4)
FRONT cross-bar using the U-bolts and plastic
knobs. (Figure 4)
NOTE: There are two different size U-bolts
provided. The size of U-bolt required depends on
the width of the vehicle Cross-bar. (Figure 5)
provided. The size of U-bolt required depends on
the width of the vehicle Cross-bar. (Figure 5)
Figure 2
90
28” Min.
“A”
Support Arm
Bracket
Bracket
VEHICLE FORWARD
Cross-bar
1-3/8” Max.
3-1/4” Max.
5/8” Min.
1-1/2” Min.
Cross-bar
Figure 5
Front Cross-bar
Support Arm
NOTE: See figure 5 for the minimum and maximum size cross-bars that this bike rack can be used.
End cap