Telex Marine Radio tr-200 用户手册
SET-UP
Unpacking: Unpack your TR-200 System. If there are any defects or shortages, re-
fer to the “Warranty Service Information” section in this manual.
fer to the “Warranty Service Information” section in this manual.
Headset Connection: Insert the headset/microphone into the connector on the bot-
tom of the unit. See the microphone connection diagram (Figure 4) if unit other
than Telex is used.
tom of the unit. See the microphone connection diagram (Figure 4) if unit other
than Telex is used.
Figure 5
Connecting Headset
Dynamic/Electret Switch: If the headset you are using has an Electret micro-
phone, the dynamic/electret switch must be in the “E” position (Electret). This
switch is accessible by removing the belt clip and removing the battery holder. A
+5 volt bias is available at the microphone plug for electret use.
phone, the dynamic/electret switch must be in the “E” position (Electret). This
switch is accessible by removing the belt clip and removing the battery holder. A
+5 volt bias is available at the microphone plug for electret use.
If you are using a headset with a dynamic microphone, place the dynamic/electret
switch in the “D” position (Dynamic). Refer to Figure 6.
switch in the “D” position (Dynamic). Refer to Figure 6.
NOTE: FOR PROPER OPERATION YOU MUST MATCH THE TYPE OF MI-
CROPHONE YOU ARE USING WITH THE DYNAMIC/ELECTRET SWITCH
LOCATED INSIDE THE UNIT.
CROPHONE YOU ARE USING WITH THE DYNAMIC/ELECTRET SWITCH
LOCATED INSIDE THE UNIT.
-7-
TO HEADSET
R