QMS 1800486-001C 用户手册
$
"
.1#
'0
+
64
#3
Single in-line memory modules (or SIMMs) are compact circuit boards with sur-
face-mount memory chips. The QMS
face-mount memory chips. The QMS
magicolor 2 DeskLaser comes with 8 MB RAM.
The QMS magicolor 2 DeskLaser duplex model comes with 32 MB RAM. However,
you can upgrade the printer to a maximum of 64 MB of RAM through the installation of
additional SIMMs. When upgrading, 8, 16, and 32 MB SIMMs with a refresh rate of
2 KHz must be used. Additional memory allows you to print complex images on large
page sizes.
you can upgrade the printer to a maximum of 64 MB of RAM through the installation of
additional SIMMs. When upgrading, 8, 16, and 32 MB SIMMs with a refresh rate of
2 KHz must be used. Additional memory allows you to print complex images on large
page sizes.
10 Snap the plastic side covers onto
the appropriate sides of the input
feeder.
feeder.
The input feeder is now installed.
»
Note:
If you move the printer with the
lower input feeder attached, lift the unit
by the four bottom corners of the
feeder, not by the feeder's cassette slot
and not by the printer itself.
by the four bottom corners of the
feeder, not by the feeder's cassette slot
and not by the printer itself.
11 Plug in the printer and turn it on.
»
Note:
In compliance with UL
guidelines, “The appliance inlet is
considered to be the main disconnect
device.”
considered to be the main disconnect
device.”