Maretron INTERNET PROTOCOL GATEWAY IPG100 用户手册

 

 

If you notice unexpected operation of the Maretron IPG100, follow the troubleshoo
procedures in this section to remedy simple problems. 
 

ting 

N2KView

®

 

Clients cannot 

1.  If you have programmed the IPG100 

is an active DHCP ser

successfully 
connect to the 
IPG100 

2.  Ensure that the NMEA 2000

®

 connection is secure, and that the NMEA

2000

®

 network is powered. 

3.  Ensure that you have entered the correct IP Address of the IPG100 

into N2KView

®

. 

4.  Ensure that the LAN LED on the IPG100 is lit, indicating an active link 

connection to the LAN. If it is not lit, check the Ethernet connection 
and make sure that the router or device to which the IPG100 is 

to use DHCP, ensure that there 

ver on your LAN. 

 

d on. 

®

 Hardware License Key is plugged into the 

n programmed into the IPG100. 

sed all of the available licenses on the 

connected is powere

5.  Ensure that a N2KView

USB port of the IPG100. 

6.  Ensure that the Password entered into N2KView

®

 under the 

“Connections Settings -> N2KServer

®

 Connection” window matches 

the password that has bee

7.  Ensure that you have not u

N2KView

®

 Hardware License Key. 

LAN indicator 
not lit 

1.  Ensure that the network cable is connected both to the IPG100 and to 

 

a switch or router or another network device. 

2.  Ensure that the device on the other end of the network cable is 

powered. 

USB indicator 
not lit 

1.  Ensure that the N2KView

®

 hardware license key is properly plugged

into the USB connector 

 

NMEA 2000

®

 

indicator not lit 

1.  Ensure that power is supplied to the NMEA 2000

®

 indicator via the

NMEA 2000

®

 cable, and that the NMEA 2000

®

 connection is sec

 

ure. 

 
If these steps do not solve your problem, please contact Maretron Technical Support (refer to 
Section 7 for contact information).