Hitachi Car Video System lcd monitor 用户手册

EN

GLISH

* Depending on the type of signal displayed, displays may not be optimized through automatic adjustment. Adjust manually to optimize them.

Vertical Filter

Turn On when concerned about screen flicker.

Frequency Mode

 Grayed out

This function is not available.

RGB1

This should correspond to the signal mode of the signal from the 

equipment that is connected to RGB1 DVI terminal.

RGB2 (1st step)

This should correspond to the signal mode of the signal from the 

equipment that is connected to RGB2 D-sub terminal.

RGB2 (2nd step)

This step should be set only when [Component] is selected on the 

1st step.

This should correspond to the signal mode of the signal from the 

equipment that is connected to RGB2 D-sub terminal.

• Normally, set this to Auto. The signal mode of the input signal 

will be automatically recognized.

• If the input signal contains much noise or has a low level at 

Auto and the operation is found erratic, set this to match the 

input signal.

OPERATING INSTRUCTIONS (continued)

SETUP MENU (RGB mode: RGB1 (DVI-PC), RGB2 (RGB)) (continued)