Whirlpool W10110521 用户手册

■

Is the dryer located in a room with temperature below
45ºF (7ºC)? 
Proper operation of dryer cycles requires temperatures above 
45ºF (7ºC).

■

Is the dryer located in a closet? 
Closet doors must have ventilation openings at the top and 
bottom of the door. The sides and front of the dryer require a 
minimum of 1" (2.5 cm) of airspace, and the rear of the dryer 
requires 5" (12.7 cm). See the Installation Instructions.

■

Has an air dry cycle been selected? 
Select the right cycle for the types of garments being dried. 

■

Is the load too large and heavy to dry quickly? 
Separate the load to tumble freely.

■

Is the automatic cycle ending early? 
The load may not be contacting the sensor strips. Level the 
dryer.

Change the dryness level setting on Automatic Cycles. 
Increasing or decreasing the dryness level will change the 
amount of drying time in a cycle.

■

Is the lint screen clogged?
Lint screen should be cleaned before each load.

■

Was dryer fabric softener properly used? 
Add dryer fabric softener sheets at the beginning of the cycle. 
Fabric softener sheets added to a partially dried load can 
stain your garments.

Drum stains are caused by dyes in clothing (usually blue 
jeans). This will not transfer to other clothing. 

■

■

Was the dryer overloaded? 
Dry smaller loads that can tumble freely.

■

Have you recently been painting, staining or varnishing in 
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone 
from the area, rewash and dry the clothing. 

■

Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor 
will be gone after the first cycle.

Before calling for assistance or service, please check 
“Troubleshooting.” If you still need help, follow the instructions 
below. 

If you need to order replacement parts, we recommend that you 
only use factory specified parts. These parts will fit right and work 
right because they are made with the same precision used to 
build every new WHIRLPOOL

®

 appliance. To locate factory 

specified parts in your area, call the dealer from whom you 
purchased the dryer or a Whirlpool designated service company.

NOTE: For gas dryers only, if the power supply cord is damaged, 
it must be replaced by a special cord available from the dealer 
from whom you purchased the dryer or a Whirlpool designated 
service company.

Contact the dealer from whom you purchased your dryer.