Raritan Computer Paragon II 255-30-6000-00 用户手册
Chapter 4: Operation - Administrator Functions
101
Video Delay
If channel switching or autoscanning takes too long to sync up on
Paragon II, especially when your servers are set with different resolutions,
it may create a displaying issue with your monitor. At this time, set a
video delay for channel port switching at your user station.
Paragon II, especially when your servers are set with different resolutions,
it may create a displaying issue with your monitor. At this time, set a
video delay for channel port switching at your user station.
If you set the video delay to any number of seconds greater than zero,
Paragon II will wait until a video signal is constant for that number of
seconds before passing it through to the monitor.
Paragon II will wait until a video signal is constant for that number of
seconds before passing it through to the monitor.
To set video delay, use any of the arrow keys to move the highlight to the
Video delay‐‐switching field, press Enter to turn the highlight green,
type the desired two‐digit delay from 00 to 30 seconds (or use the Ï and
Ð keys to increase or decrease the value by 1), and press Enter again to
select it.
Video delay‐‐switching field, press Enter to turn the highlight green,
type the desired two‐digit delay from 00 to 30 seconds (or use the Ï and
Ð keys to increase or decrease the value by 1), and press Enter again to
select it.
Press S to save the changes, or press Esc and then N to exit without
saving changes. The changes are applied only to your user station (the
station at which the change was made).
saving changes. The changes are applied only to your user station (the
station at which the change was made).