Sony STR-DH520 操作指南

D:\NORM'S JOB\SONY HA\SO0109\STR-DH520\4263361111_GB\GB06ENJ_STR-DH520-U2.fm

STR-DH520

4-263-361-11(1)

 

 

 

 

You can only select the following sound fields 
if the headphones are connected to the 
receiver.

x HP 2CH (Headphones 2CH)

This mode is selected automatically if you use 
headphones (except Analog Direct). Standard 
2 channel stereo sources completely bypass 
the sound field processing and multi channel 
surround formats are downmixed to 2 
channels except LFE signals.

x HP DIR (Headphones Direct)

This mode is selected automatically if you use 
headphones and when “A. DIRECT” is 
selected.
Outputs the analog signals without processing 
by the equalizer, sound field, etc.

This receiver will generate a low frequency 
signal for output to the subwoofer when there 
is no LFE signal, which is a low-pass sound 
effect output from a subwoofer to a 2 channel 
signal. However, the low frequency signal is 
not generated for “NEO6 CIN” or “NEO6 
MUS” when all speakers are set to “LARGE”. 
In order to take full advantage of the Dolby 
Digital bass redirection circuitry, we 
recommend setting the subwoofer’s cut off 
frequency as high as possible.

• Depends on the speaker pattern settings, 

some sound fields may not be available.

• The sound fields for music and movie do not 

work in the following cases.

– DTS-HD Master Audio, DTS-HD High 

Resolution Audio or Dolby TrueHD with 
sampling frequency of more than 48 kHz 
are being received.

– “A. DIRECT” is selected.

• “PLII MV”, “PLIIX MV”, “PLII MS”, 

“PLIIX MS”, “PLIIZ”, “NEO6 CIN” and 
“NEO6 MUS” also do not work when the 
speaker pattern is set to 2/0 or 2/0.1.

• You cannot select “PLIIX” and “PLIIZ” at 

the same time.
– “PLIIX” is available only when the 

speaker pattern is set to a setting with 
surround back speaker(s).

– “PLIIZ” is available only when the 

speaker pattern is set to a setting with front 
high speakers.

• When one of the sound fields for music is 

selected, no sound is output from the 
subwoofer if all the speakers are set to 
“LARGE” in the SPEAKER menu. 

 

However, the sound will be output from the 
subwoofer if
– the digital input signal contains LFE 

signals.

– the front or surround speakers are set to 

“SMALL”.

– “MULTI ST.”, “PLII MV”, “PLII MS”, 

“PLIIX MV”, “PLIIX MS”, “HD-D.C.S.” 
or “P. AUDIO” is selected.

Press SOUND FIELD +/– repeatedly to select 
“2CH ST.” or “A.F.D. AUTO”.
You can also repeatedly press 

 

2CH/A.DIRECT or press A.F.D on the 
receiver to select  “2CH ST.” or “A.F.D. 
AUTO” respectively.