Symphonic ZEKTOR MAS3 用户手册

7

1 Place the MAS3 in standby mode. This is the factory default mode 

on power up, and if it has not been changed, you can unplug the 

MAS3 and plug it back in and it will power up in standby mode (at 

this point only the power indicator light is lit and glowing RED). If 

the MAS3 does not power up in standby mode, follow the steps 

given in "Restoring the MAS3 to Factory Defaults" on page 13.

2 On your remote control press the buttons in the following 

sequence, after each button press verify that the remote IR 

indicator flashes. (If you make a mistake, you can start over by 

pressing P

 twice.):

3 The MAS3 will power up indicating the new component codes have 

been accepted.

Searching for a component code in your remote

Assuming you do not have a remote listed in this user manual you will have to follow your remote 

controls programming sequences to find a compatible component that the MAS3 understands, or 

you can go to the section "Learning New Remote Codes" on page 8, to teach the MAS3 new keys 

for individual commands.
To search for compatible component codes you must place the MAS3 in standby mode and try 

manufacturer codes in your remote control until one of them causes the MAS3’s IR indicator LED 

to flash.

1 Place the MAS3 in standby mode. This is the factory default mode 

on power up, and if it has not been changed, you can unplug the 

MAS3 and plug it back in and it will power up in standby mode (at 

this point only the power indicator light is lit and glowing RED). If 

the MAS3 does not power up in standby mode, follow the steps 

given in "Restoring the MAS3 to Factory Defaults" on page 13.

2 Try different manufacturer codes until one of them causes the IR 

indicator light on the MAS3 to blink when pressing the 
P

 key. When found, go to back to "Teaching the 

MAS3 a new component code" on page 6, to teach the MAS3 to 

use the new component code.

3

2

1

3

2

1

3

2

1

3

2

1

3

2

1